I take that back, actually. Probably no even possible to "flesh out" a 
path. The reason being that high-adjust-ability paths use both a vector, 
which defines location of the control, and angle *and* a value between 0 
and 1, which determines how "tight" or "loose" the curve gets, from 
nearly formless, to a sharp corner. Needless to say, Catt-mull Rom 
curves have no way to handle either of the later parameters.

<A HREF='http://www.daz3d.com/index.php?refid=16130551'>Get 3D Models, 
3D Content, and 3D Software at DAZ3D!</A>

Post a reply to this message