On 21/06/2010 11:41 AM, Invisible wrote:
>
> (It turns out we have a machine that takes measurements in microseimens,
> but some software we use needs a value in milivolts. And while they are
> completely different dimensions, if you knew the properties of the
> machine, it's conceivable that a constant conversion factor actually
> exists...)

You have a machine that displays measurements in microseimens. 
Internally it will probably measure them in millivolts or milliamps. For 
conversion you need to make sure that the conversion should be linear, 
it might not be.

-- 

Best Regards,
	Stephen

Post a reply to this message