On 07/06/2010 8:02 PM, Orchid XP v8 wrote:
>>> When I was soldering one of the components, the solder spilt onto the
>>> adjacent track. I've tried to fix at a dozen times now, but I'm still
>>> getting continuity somehow...
>>>
>>
>> Do you have some copper braid or a solder pump? that should clean it off.
>
> There was a blob of solder between the tracks. So, as per the
> instructions in my trusty old electronics book, I ran the point of the
> iron down the groove between the tracks.
>
> In three cases, this fixed the problem. In the forth case, a short
> circuit still exists somehow.
>

A sharp knife or a scalpel works wonders.
You need the right tools to do the job.

-- 

Best Regards,
	Stephen

Post a reply to this message