Am 29.04.2010 05:34, schrieb Patrick Elliott:

> As a rule, the word "set" is almost **never** used in VB, at all. I
> think there may be some obscure cases where you may use it, but, in
> general, its little more than a hold over from ages past, when it was
> mandatory. It hasn't been in most BASICs for... at least DOS1.0, maybe?

That would be true for "let".

As for "set", it has been mandatory at least in every version of VBA 
that I ever touched. Not sure about full-fledged VB though.

Post a reply to this message