Jim Holsenback wrote:
> "Stephen" <mca### [at] aolDOTcom> wrote in message 
> news:4b4f295b$1@news.povray.org...
>> You would probably get some help at the Bishop3D forums, if you ask.
>> Miri is quite good at making these forms free hand. She created some grass 
>> leaves as I remember. There is also a method of uploading control points 
>> from a file if you can get a way of calculating them. Or you can use your 
>> own SDL code with the raw script plugin.
> 
> JimC's approach shows promise, and it also off loads my guilt about using 
> Bishop after the trial period. I MUST find money in my budget if I'm going 
> to continue using it.
> 

There is that, personally I think it is a bit overpriced. One of the 
benefits of testing is getting a free copy :D




-- 

Best Regards,
	Stephen

Post a reply to this message