|
![](/i/fill.gif) |
neodasa <klu### [at] nyc rr com> wrote:
> as per the instruction to smooth out the seam, but when I tested a control point
> and raised the seam, it appeared as a sharp edge rather than a smooth edge,
> which is what it's not suppose to do. Anyone know why this happened?
For two adjacent bicubic patches to form a smooth surface the control
points in the shared edge must be equal, and the closest inner control
points of each patch, along with their correspondent edge control point,
must form a straight line.
--
- Warp
Post a reply to this message
|
![](/i/fill.gif) |