|
|
scott wrote:
>> How many resistors can you see? Because I count NONE!
>
> Sure, but that circuit does not show how you generate the inputs A,B,Cin
> or how to connect the output to an LED.
>
> Both of which require some basic knowledge of analogue electronics.
NNOOOOOOOOOO!!!! X_X
Well anyway, FWIW, the IC managed to drive the LED just fine. (I bought
special 5V LEDs; apparently normal ones take roughly 3V.) It's just that
I couldn't get the right truth table out of it. :-(
You think using a 2-pole switch with the poles connected to each of the
power rails will do it?
Post a reply to this message
|
|