Archpawn <nomail@nomail> wrote:
> I'm trying to make a branching lightning bolt using a series of cones with media
> in them. The cones connect to each other, but when I make them transparent so I
> can only see the media, there are gaps between them.

  Add the keyword 'open' to the cones to remove the endcaps.

  If there joints are still visible it means that there are holes in
your series-of-connected-cones. You have to either position the cones
better, of you have to use some other method. Look at the documentation
about sphere sweeps.

-- 
                                                          - Warp

Post a reply to this message