Shai <rec### [at] hotmailcom> wrote:
> The meshes are not closed. Basically I started with a .OBJ file of the
> Stanford Bunny. I then wrote a program that would remove the back of the
> bunny, leaving me with only its front.

  Given that the mesh is transparent how could you expect it to work
correctly if parts of the surface have been removed?

> How could I fix this? Is there any command that allows me to work around
> this?

  How do you expect POV-Ray to create a part of the mesh which isn't there?

-- 
                                                          - Warp

Post a reply to this message