|
|
scorpmetal <sco### [at] yahoocom> wrote:
> I my new question: I want to keep all of measure in pov-ray by mm( or cm).
> Where in povray i can do that? Or what is the measure defaut of povray? (
> sorry with my poor english)
One unit is one unit. If the length of an object is 1.0, then the
length of the object is 1.0. There's nothing else to that.
You can yourself decide what that 1.0 means. Does it mean 1 meter,
1 cm, 1 mm, 1 inch, 1 foot? It's up to you.
You should consistently think about one POV-Ray unit as a certain
length unit (eg. cm) and design everything with that in mind.
You don't tell POV-Ray that 1.0 means 1 cm. You just think it yourself
that way.
--
#macro N(D)#if(D>99)cylinder{M()#local D=div(D,104);M().5,2pigment{rgb M()}}
N(D)#end#end#macro M()<mod(D,13)-6mod(div(D,13)8)-3,10>#end blob{
N(11117333955)N(4254934330)N(3900569407)N(7382340)N(3358)N(970)}// - Warp -
Post a reply to this message
|
|