Rick Measham wrote:
> I have a box with a hole in it. The whole was made by differencing a
> Round_Box so that the corners were nicer than the traditional square
> corners. However the opening of the hole still has hard square edges:
> ___ __
> | |
> | |
> |____|
>
> How would you go about rounding them?
> ___ __
> \ /
> | |
> |____|
>
>
> I've thrown away my first idea, which was to put cylinders around the
> four sides of the box (first subtracting the radius as a box) but that
> only works along the sides of the hole. I need the corners to be nicely
> rounded too.
>
> Any help and suggestions would be greatly appreciated.
I think the keyword you are looking for here is: *lathe*
--
Maurice
Post a reply to this message
|