I would try this, maybe in a macro:
First cut out the hole like you did
> ___ __
> | |
> | |
> |____|
Then cut out a hole not so deep but with a bigger radius
__ __
|_ _|
| |
|____|
The last thing is placing a torus that way, that it fills the edges. The
major radius for the torus is the radius for the bigger hole and the
minor radius is the radius for the first hole you made.
___ _ _ ___
| |_\ /_| |
\___| |___/<-- this is the torus
|____|
I hope this is clear enough.
I also could post some code if you wish...
So long,
Bonsai
--
<--------------------------->
___ __ __ _ ___ ___ _
| _ ) \ \( ) _) _ )( )
| _ \() |\ \ |\ \/ _ \| |
|___/__/_)\__)___)/ \_)_)
www.b0n541.net
<--------------------------->
Post a reply to this message
|