Sorry, my bad.

I had put the DoMySaveFile call outside the topology{} block, NOT outside the
mechsim{} block.

NOW I have the DoMySaveFile call outside the mechsim{} block, and it's working like a
charm.  Thank you very much for your help.

Christoph wrote:
>
>
> Tom Bates wrote:
> >
> > [...]
> >
> > Out of curiosity, though, I moved the DoMySaveFile call to just after the
machsim{}
> > block, as suggested, to see if that change alone would make a difference.  Sadly
it
> > did not.
>
> So what you are saying is that you generate a topology, run simulation and
> the data accessed via 'mechsim:mass(i):position' etc. afterwards is not
> different from before?
>
> Now that's peculiar...
>
> I'd suggest you really check this in detail because there is likely to be
> some fault.
>
> If you are extremely sure it works this way please create a minimal test
> scene (a single mass should suffice) so i can test it.
>
> Christoph
>
> --
> POV-Ray tutorials, include files, Sim-POV,
> HCR-Edit and more: http://www.tu-bs.de/~y0013390/
> Last updated 17 Jun. 2003 _____./\/^>_*_<^\/\.______

Post a reply to this message