"Shay" <sah### [at] simcopartscom> wrote in message
news:3da354a4$1@news.povray.org...

> This may be a lot simpler than I thought. All that is really needed is to
> reorganize the data you have into a heightfield type mesh2 formal. I have
a
> macro at home that can do this. I will post it tomorrow.

Wonderful!  I'd love to see it.

> Smoothing out the surface is another problem. This can be accomplished
> easily with a mesh subdivision, but smooth surfaces which travel *through*
a
> set of points have a tendency to warp and look wavy.

I'll give your macro a go, and see where it gets me.  At this point,
anything is an improvement.  Again, thanks, Shay.

- How

Post a reply to this message