(I posted this in p.b.utilities but I'm not sure if that was the place to
post it...)
In Hamapatch, how do you go about using the Set Curve Weit (weight?) feature
by inputting the curve numerically (much like being able to rotate by
specifying, for example, 30 degrees) rather than by just using the mouse and
guessing. I have a symmetric object with curves that need to match on both
sides and am having frustration not being able to input the Curve Weit
numerically. I looked through the documentation but may have overlooked if
this is possible or not.
-Paragon
Post a reply to this message
|