The Start_Row doesn't work with Continue. If I use them both the trace
starts at the last line that was rendered rather than actually starting at
the +SR point. For example I have an image that is 1280x1024. The render
had completed down to row 700. I wanted to basically continue the trace but
starting back at line 450. If I use +c +SR450 the trace starts at 700. If
I leave out the +c then the upper portion (1 to 449) is left out.
My main reason for not simply starting over is the amount of time the render
requires (4 days.)
I found a sloppy way of doing what I want by opening the BMP within a paint
program and copying the blank/black area below the image back up into the
rendered area. (I noticed this area was all black with a thin line of color
on the far left side) Then using the +c it is starting back at 450 as I
wished. I just though there must be an easier way to request a +c AND
+sr450 that would re-render (overwrite) from that starting point even though
the image was actually past that point.
"Christoph Hormann" <chr### [at] gmxde> wrote in message
news:3D4D75D7.A2C252F0@gmx.de...
>
>
> Patrick Dugan wrote:
> >
> > Before you answer with RTFM I have read the manual and cannot determine
the
> > answer from it.
>
> Maybe read section 5.2.2.1.2 again... ;-)
>
> Christoph
>
> --
> POV-Ray tutorials, IsoWood include,
> TransSkin and more: http://www.tu-bs.de/~y0013390/
> Last updated 03 Aug. 2002 _____./\/^>_*_<^\/\.______
Post a reply to this message
|