Emmajg wrote in message <3bf40fbb@news.povray.org>...
>Anyone know of a good converter preferably free or not too expensive
to
>buy??


The best is probably 3dWin (www.stmuc.com/thbaier) which, in general,
does a wonderful job.But I don't know whether it handles the stuff
AME3d stuff: Many times, I've found, even Autocad won't properly open
files thrown at it from ADT, AME etc (though those were .dwg, not
.dxf).

One solution to this would be to export .3ds. Another: when exporting
.dxf, specify dxf14 (or 13 or 12) : a lot of programs, including 3dWin
don't open dxf2000.

Hope this helps.

-Anoop

Post a reply to this message