hello all!

i have a disk which is WIP. as i raytraced it in four views i found out 
that (in my eyes) lines are missing if the camera goes a little bit away. 
the disk is an ellipsoid from which boxes are differenced. the area for the 
label is 5mm lower than the other areas. now the border of this label area 
is gone.
my reality template shows the lines. what does it depend on and what did i 
wrong? and why are some lines interrupted although i commanded povray to 
antialiase?
for visualisation i sent a pic to povray.binaries.images.

Post a reply to this message