Did you try applying smooth normals in Crossroads 3D (you'll need to
_Select All_ and then choose _Smooth_ from the menu after right-clicking
on the model window).

Abe

Artis wrote:
> 
> > I had to slog my way through this same problem a short while ago. I not
> > sure of the cause but I suspect it may have to do with whether or not
> > the origional model was supplied with normals. (In my case I had a
> > Hammapatch model that I wanted to UV map.)
> >
> > My solution was to run the model through Crossroads 3D and have the
> > normals calculated there before going on.
> 
> I am using a hamapatch model too, but Crossroads 3D doesn't helps.

Post a reply to this message