I say again, I think DTA32 will do it even though I haven't checked.  All
you'd need do is append each frame as a post command via the INI file and
delete the frame after that.  A batch file would be needed also, use it to
set up DTA for the input with required parameters.  I may want to give DTA32
a try again myself just to see if this works.

Bob

Rick <pov### [at] dialpipexcom> wrote in message
news:381d71c6@news.povray.org...
> I dont think you can do this, not untill POVray directly supports AVI or
> MPEG export
>
> I have always used the huge stock of frames method !
>
> Rick
> David Vincent-Jones <geo### [at] galaxynetcom> wrote in message
> news:381cc1d0@news.povray.org...
> > Let me try again;
> > Rather than produce 500 frames which are to be stored prior to assembly
> and
> > compression I had hoped that there would be a program that took the
> > individual frames as they were produced and create the AVI on the 'fly'
> > without burdening my system with the multiple frames.
> >
> > Maybe I should have asked, what is the best software solution to
producing
> > AVI specifically from POV Ray?
> >
> > Nieminen Juha <war### [at] punarastascstutfi> wrote in message
> > news:381bfadb@news.povray.org...
> > > David Vincent-Jones <geo### [at] galaxynetcom> wrote:
> > > : Which , if any, animation programs are directly able to take POV Ray
> > output
> > > : files as they are produced and create an AVI or MPEG clip.
> > > : The descriptions that I am seeing, so far, look as if most programs
> are
> > only
> > > : assembling a series of frames.
> > >
> > >   I don't understand. The povray output are frames, so any program
that
> > > assembles a series of frames will do it.
> > >   Perhaps you could formulate your question better?
> > >
> > > --
> > >
main(i,_){for(_?--i,main(i+2,"FhhQHFIJD|FQTITFN]zRFHhhTBFHhhTBFysdB"[i]
> > > ):5;i&&_>1;printf("%s",_-70?_&1?"[]":" ":(_=0,"\n")),_/=2);} /*-
> Warp -*/
> >
> >
>
>

Post a reply to this message