On Thu, 22 Jul 1999 09:30:06 +0200, Marc Schimmler <sch### [at] icauni-stuttgartde>
wrote:

>
>Thanks David! 
>
>I will have a look at it. About two weeks ago the Loial Raven sent me
>his version of a gear macro. He hasn't decided yet to publish it but I
>would strongly encourage him to do so. It's much faster than mine when
>it comes to csg because of the bounding he uses and it's a macro and not
>an include file like mine (at time I was writing this no 3.1 version for
>linux existed). Maybe I find some to improve my file and change it to a
>macro.
>I would also like to learn about the diametral pitch. If you have a
>pointer for me I would be quite happy. My long term plan is to create a
>library of technical parts for povray to have the possibility to
>visualize mechanical constructions.
>
>
Hi Marc,

I added semicolons to the ends of your #declare statements and ran your example under
3.1g.  I then changed my example to match yours as nearly as possible (same texture
and
numbers of teeth).  The times came out as 166 secs for yours and 34 secs for mine in
rendering one frame at 800x600.  I didn't set out to make it speedy so I find this
quite
surprising.  This is on a 350P2 with 64Mb.
Diametral pitch (DP) is just the number of teeth per unit diameter (usually inches). 
The
addendum of the gear tooth is normally 1/DP and the dedendum 1.25/DP or slightly less.

Cheers,
David
------------
dav### [at] cwcomnet
http://www.hamiltonite.mcmail.com
------------

Post a reply to this message