Wasn't it Maurice who wrote:
>Rick Measham wrote:
>> I have a box with a hole in it. The whole was made by differencing a
>> Round_Box so that the corners were nicer than the traditional square
>> corners. However the opening of the hole still has hard square edges:
>> ___ __
>> | |
>> | |
>> |____|
>>
>> How would you go about rounding them?
>> ___ __
>> \ /
>> | |
>> |____|
>>
>>
>> I've thrown away my first idea, which was to put cylinders around the
>> four sides of the box (first subtracting the radius as a box) but that
>> only works along the sides of the hole. I need the corners to be nicely
>> rounded too.
>>
>> Any help and suggestions would be greatly appreciated.
>
>I think the keyword you are looking for here is: *lathe*
Wouldn't that tend to make a cylindrical hole rather than a rounded
square hole?
--
Mike Williams
Gentleman of Leisure
Post a reply to this message
|