On 5/17/2021 4:47 AM, Thomas de Groot wrote:
> Op 17/05/2021 om 09:57 schreef Mike Horvath:
>> I attached new terrain with a single mesh2 object, but the issue 
>> persists! :(
>>
> 
> As /last/ line inside the mesh2 {} add the following line:
> 
> inside_vector <0,0,1>
> 
> For good measure, add the line also to the sf_terrain_water_dot_ldr 
> mesh2 object.
> 
> Then it works, at least in my system.
> 

It is still not working for me. There are no errors or warnings, but the 
spheres and cones are still at y = 0 instead of conforming to the hills.

Can you upload your working files?


Mike

Post a reply to this message