|
 |
"St." <dot [at] dot com> wrote:
> Stephen, in Wings, there's a 'combine' command that will do this.
>
> I'm not sure if there is a scaling problem with 3DS files in Wings,
> but I would try converting to OBJ if there is, (seems to keep scale ok).
>
> ~Steve~
>
Thanks Steve, I couldn’t find a “combine” command but in materials I was
able to “assign” all the faces I wanted, to one material, and then delete
the others. I’m a bit worried because everyone says that there is a steep
learning curve with Wings. I thought that the little I did was quite
intuitive. In other words I don’t know exactly what I did after pressing
every button in sight :-)
There is still a problem importing back into Poser so I must be doing
something wrong either exporting from or importing to Poser.
Stephen
Post a reply to this message
|
|
