"William Pokorny" <pokorny_epix_net> wrote:
> I too am running Linux. I just ran Spilin, of which I knew not (thanks Chris),
> under wine and it appears to run fine should you want to give Spilin a go that
> way.
>
> "Jovian Ghost" <nomail@nomail> wrote:
> > Unfortunately I'm running the Linux version of POV-Ray, so I can't use Spilin; a
> > quick Google reveals it's a Windows app.
> >
> > In my understand is correct, your Inkscape method describes creating a curved
> > line with a lot of straight lines.
> > I would prefer to use curved splines if I can.

Thanks for everyone's replies!
I'm experimenting with different methods right now actually, and may not go with
the splines method in the end. But good to know that Spilin runs under WINE,
thanks William. :)

Post a reply to this message

Jim Charter <jrc### [at] msncom> wrote:
> Jovian Ghost wrote:
> It resided on a geocities site and I note that there is an effort to
> preserve early POV contributions which resided there even as we speak.
> The thread is in p.general
>
> I do have a copy of those (very useful) macros if you cannot get it any
> other way.

Hi Jim.

I hit the same problem, and after looking around for some time, I did find a
copy of spline.inc, but, as yet, I couldn't find any documentation. I'd
appreciate any leads!

Happy 2010!

John

Post a reply to this message

John wrote:
> Jim Charter <jrc### [at] msncom> wrote:
>> Jovian Ghost wrote:
>> It resided on a geocities site and I note that there is an effort to
>> preserve early POV contributions which resided there even as we speak.
>> The thread is in p.general
>>
>> I do have a copy of those (very useful) macros if you cannot get it any
>> other way.
> 
> Hi Jim.
> 
> I hit the same problem, and after looking around for some time, I did find a
> copy of spline.inc, but, as yet, I couldn't find any documentation. I'd
> appreciate any leads!
> 
> Happy 2010!
> 
> John
> 
> 
> 
Hmmmm Shame, yes there was some nice documentation online in html.  I 
didn't copy it.  I have only the Quickref file.

Post a reply to this message