Op 17/08/2022 om 17:29 schreef Alain Martel:
> You should try the inverse kynetic neck (ot IKN) macro that was 
> published in one of the news groups. It takes two end points, a 
> stiffness parameter at both ends, a twist value at each end, and a total 
> length as input. It returns a spline of the correct length connecting 
> the end points, or an error message if the end points are to far apart.

I think that the macro mentioned here is by Rune Johansen, and can be 
found at this page:

https://runevision.com/3d/include/

-- 
Thomas

Post a reply to this message