POV-Ray: Newsgroups: povray.general: Mesh compression/PCM macro?

POV-Ray : Newsgroups : povray.general : Mesh compression/PCM macro?		Server Time 29 Nov 2024 19:57:43 EST (-0500)

From: Tom York
Subject: Mesh compression/PCM macro?
Date: 29 May 2005 11:10:01
Message: <web.4299dab644818760e0d101b60@news.povray.org>

What was the last version of this system (written by Chris Colefax and Warp,
IIRC) to be released? I've found a beta of 3.0 - was that version ever
finalised?

Tom

Post a reply to this message

From: Warp
Subject: Re: Mesh compression/PCM macro?
Date: 29 May 2005 11:34:17
Message: <4299e0f9@news.povray.org>

Tom York <alp### [at] zubenelgenubi34spcom> wrote:
> What was the last version of this system (written by Chris Colefax and Warp,
> IIRC) to be released? I've found a beta of 3.0 - was that version ever
> finalised?

  Chris has probably been quite busy.

  Perhaps someone could make an "unofficial" third-party upgrade to the
macros to support the new format?

-- 
                                                          - Warp

Post a reply to this message

From: Tom York
Subject: Re: Mesh compression/PCM macro?
Date: 29 May 2005 15:25:26
Message: <Xns9665CFAA4A72Dalphanullspamzubenel@203.29.75.35>

Warp <war### [at] tagpovrayorg> wrote in news:4299e0f9@news.povray.org:

>   Chris has probably been quite busy.
> 
>   Perhaps someone could make an "unofficial" third-party upgrade to
>   the 
> macros to support the new format?
> 

Sure, I'll give it a go. I have the PCM4 format documentation in the 
meshcomp.txt file from the beta.

BTW, is it just me or is the web view not showing replies to messages 
posted via the web?

Thanks,

Tom

Post a reply to this message