|
 |
Not positive of your intent here, however you might be looking for Subset_Start_Frame=
and Subset_End_Frame= lines for the INI used to do animation (also known as +sf and
+ef
on the command line). Put the number of the frame you want rendered after these (same
for both, makes single image) or use a decimal between 0 and 1, inclusive, for a
percentage within the animation ( +sf0.5 +ef0.5 of a 30 frame total makes this 15).
simon long wrote:
>
> I RUN A PROGRAMME CALLED PRO/ENGINEER AND ALTHOUGH I CAN RENDER IN POV RAY
> IF I CREATE AN ANIMATION , HOW DO I DO THIS FOR A SINGLE IMAGE?
> REGARDS
> SIMON
--
omniVERSE: beyond the universe
http://members.aol.com/inversez/homepage.htm
mailto://inversez@aol.com?Subject=PoV-News
Post a reply to this message
|
|
