"LanuHum" <Lan### [at] yandexru> wrote:
> Why there was a question?
> If I have the correct visualization of a curve in the editor, I can create
> Constructive Solid Geometry.
> On the picture green prism (bezier_spline) and red curve (bezier_spline).
> If sphere_sweep, also as the prism, supported bezier_spline, it is possible to
> write:
> difference{
>     object{prism}
>     object(sphere_sweep}}
>
> I can't make it.
> I can't reel up a spiral on SOR.
> I can SOR and sphere_sweep to model as nurbs, but to write down as cubic.
> But, if to displace control points of a curve on Z, the geometry will be broken,
> but control is absent also correction not to make.

If bezier spline is nothing else than a cubic spline, maybe I can write a macro
for converting.

Post a reply to this message

> If bezier spline is nothing else than a cubic spline, maybe I can write a macro
> for converting.

http://www.joshuarenglish.com/cyclopedia/bezier.html

Post a reply to this message

scott <sco### [at] scottcom> wrote:
> > If bezier spline is nothing else than a cubic spline, maybe I can write a macro
> > for converting.
>
> http://www.joshuarenglish.com/cyclopedia/bezier.html

Uh huh,.. okay, I will try it.

Post a reply to this message

"And" <49341109@ntnu.edu.tw> wrote:

>
> If bezier spline is nothing else than a cubic spline, maybe I can write a macro
> for converting.

Thanks!

Post a reply to this message