Howdy,
See the attached ..... given these settings I was hoping to get some
help/advice on the results of a radiosity run ....
#if (UseRad)
radiosity {
pretrace_start 0.08
pretrace_end 0.005
count 200
nearest_count 8
error_bound 0.7
recursion_limit 1
low_error_factor 0.4
gray_threshold 0.4
minimum_reuse 0.0075
brightness 2.8
normal on
always_sample off
adc_bailout 0.01/2
}
ambient_light 0
#end
I've scaled my stucco texture in some places ..... wall with hurricane lamps
and the inside of the archways and I'm mostly satisified, however I
concerned about the appearance of the surface normals on the towers to the
left and right of the central tower. Question .... will I be able to smooth
those out with aa? This run I used +am1 +a0.03 +r3 ..... currently it takes
just under two hours, so I'm anxious to resolve the mentioned problem before
I commit to a "beauty" run .... +am2 +a0.1 +r2???? Oh yeah .... I'm leaning
towards changing the light source in the close up alcove ..... I'm not 100%
happy with that.
Thanks Jim
Post a reply to this message
Attachments:
Download 'Courtyard.jpg' (71 KB)
Preview of image 'Courtyard.jpg'
|
