On Fri, 16 Apr 2004 11:38:17 -0400, Christopher James Huff wrote:

> In article <pan### [at] ednetrvcccilus>,
>  David <dsf### [at] ednetrvcccilus> wrote:
> 
>> > Probably the easiest way is to use ImageMagick convert, but it doesn't 
>> > give you any control over the encoding (at least not that I've found).
>> 
>> Have you tried using mpeg2encode?   that's what I've used in the past
>> to create animations.
> 
> Not that I can recall...I'll look it up.

You can find it at ftp://ftp.mpeg.org/pub/mpeg/mssg

I used gimp to generate the config file for it.  check out povray.unix. 
There was a discussion I was involved in dated 01/12/02 concerning some
problems I had with it

Good luck!

David

Post a reply to this message