Le 17-03-22 à 04:27, Mike Horvath a écrit :
> On 3/21/2017 11:12 PM, Mike Horvath wrote:
>> The CMFs I am currently using are in 5nm steps from 360nm to 830nm,
>> which is 95 steps total.
>>
>> Are there more detailed samples? Are there more detailed samples for D65
>> illumination too? The CMFs and illuminations should have the same number
>> of steps in the same range, since my script is set up to iterate through
>> both sets of samples at the same time. Not sure what to do if the sample
>> tables aren't the same sizes.
>>
>> Thanks.
>>
>>
>> Mike
>
>
> Wikipedia says you can just interpolate between the 5nm points to
> generate narrower ones. Lightsys uses a spline apparently.
>
>
> Mike

Yes, Lightsys use splines everywhere.
Most of the time, a linear spline is enough, but you may want to use 
some other kind of spline.

Post a reply to this message