Oops. Just discovered this group. I was wondering what happened with
that idea!
I put a lot of time from this round's entry on trying to push through a
workflow which would involve modelling a figure in Wings, importing into
P4 using Phibuilder, then posing the figure in P4 and exporting either
to Wings for fine tailoring or to Poseray for conversion to POV. I had
some success with this but there are still major obstacles to it being a
useful workflow. In the end I found I could pose my figure more
effectively in Wings itself. But I learned a lot about Poser, .phi and
.cr files so far.
Post a reply to this message
|